The ST-42D is a new design on communication cabinets, being as rigid as steel & yet noticeably lighter than the old heavy steel constructed cabinets. This is made possible with our own aluminum recipe called ALUMIFLEX. The ST series are the most versatile cabinets in the market place today. Being designed for our continuously changing industry, the ST series is ahead of the competition in cost, weight, and expansion capabilities.
Unlike the steel cabinets, our ST-42D, made of ALUMIFLEX, will operate without affecting or being effected by RF influences. Order our ST-42D, the new industry standard, and take care of today's needs while at the same time preparing for tomorrow's expansion requirements.
Two - secured with non-intrusion locks
Locks and unlocks with a supplied set of keys
Designed to mount either left or right
Material
.1 ALUMIFLEX (our own aluminum recipe)
Finish: Cream, textured, powder baked on paint
RF properties: Non-ferrous
Vents
Two - 8" X 10" standard filter panel housings
One removable filter panel per door
Solid panels can be used for non ventilation
Access Holes
One - One inch hole / with hole plug installed
Exterior Screws
Stainless with nylon locking nuts
Racking Specifications
Rails
Two standard (For additional rails see accessories)
Alodine coated
Holes tapped to accept standard 1032 screws
Each rail supported by two R-STRUTS
.125 material (ALUMIFLEX)
Spacing
19" EIA STANDARD
Positioning
All rails fully adjustable from front to rear
Useable Height
42 inches
Useable Depth
Maximum: 16 11/16" Minimum:14 15/16" (see below)
*Section Starting & Ending Points
Vertical Height Per section
Effective Depth For Each Section
Top
40.32"- 42.00"
1.68"
14 15/16"
25.00" - 40.32"
15.32"
16 11/16"
Center
17.00" - 25.00"
8.00"
16 3/16"
1.68" - 17.00"
15.32"
16 11/16"
Bottom
0.00" - 1.68
1.68"
14 15/16"
*Section measurements start from the bottom of the cabinet (0.00")
& run vertically upward towards the top of the cabinet
